Experimental Investigation of Zinc Antimonide Thin Film Thermoelectric Element over Wide Range of Operating Conditions

Research output: Contribution to journalJournal article

Abstract

Zinc antimonide compounds are among the most efficient thermoelectric (TE) materials with exceptional low thermal conductivity at moderate temperatures up to 350 °C. This study aims to evaluate the performance of a zinc antimonide thin film TE deposited on an insulating substrate, while the heat flows in plane with the thin film. At first, the effect of applying different temperatures at the hot side of the specimen is investigated to reach steady state in an open circuit analysis. Then, the study focuses on performance and stability analysis of the thermoelectric element operating under different resistive loads and over a wide range of operating temperatures from 160 °C to 350 °C. The results show that, at a hot side temperature equal to 275 °C, the Seebeck coefficient (α) reaches its maximum value (242 μV/K), which is comparable to that of bulk materials reported in the literature. According to a variation of the load resistance, the maximum power output, that is a function of temperature, occurs at 170.25 Ω. The maximum power is 8.46 μW corresponding to a cold and hot side temperature of ≈ 30 °C and 350 °C, respectively.
Close

Details

Zinc antimonide compounds are among the most efficient thermoelectric (TE) materials with exceptional low thermal conductivity at moderate temperatures up to 350 °C. This study aims to evaluate the performance of a zinc antimonide thin film TE deposited on an insulating substrate, while the heat flows in plane with the thin film. At first, the effect of applying different temperatures at the hot side of the specimen is investigated to reach steady state in an open circuit analysis. Then, the study focuses on performance and stability analysis of the thermoelectric element operating under different resistive loads and over a wide range of operating temperatures from 160 °C to 350 °C. The results show that, at a hot side temperature equal to 275 °C, the Seebeck coefficient (α) reaches its maximum value (242 μV/K), which is comparable to that of bulk materials reported in the literature. According to a variation of the load resistance, the maximum power output, that is a function of temperature, occurs at 170.25 Ω. The maximum power is 8.46 μW corresponding to a cold and hot side temperature of ≈ 30 °C and 350 °C, respectively.
Original languageEnglish
Article number1700301
JournalPhysica Status Solidi. A: Applications and Materials Science
Volume214
Issue number11
Number of pages7
ISSN1862-6300
DOI
StatePublished - Nov 2017
Publication categoryResearch
Peer-reviewedYes

    Research areas

  • Thin Film TEG, Maximum Output Power, Seebeck Coefficient, Zinc Antimonide, Load Resistance
ID: 262082109