TY - JOUR
T1 - Pulsed power load effect mitigation in DC shipboard microgrids
T2 - a constrained model predictive approach
AU - Vafamand, Navid
AU - Mardani, Mohammad Mehdi
AU - Khooban, Mohammad Hassan
AU - Blaabjerg, Frede
AU - Boudjadar, Jalil
PY - 2019/8
Y1 - 2019/8
N2 - This paper proposes a novel model predictive controller to minimise the effect of unknown pulsed loads on the DC microgrid (MG) side of shipboards. It is assumed that the level of the pulsed power loads (PPLs) is not determined in prior for which the authors propose a novel non-linear power observer. By employing the so-called freezing technique, a novel model predictive scheme is utilised to optimally stabilise the overall DC shipboard MG. Furthermore, different constraints on the current of the DC source and the energy storage system (ESS) are considered in the predictive controller to make it more realistic and practical. Compared to the exiting results, the proposed approach can optimally design the injecting current of the ESS so that the practical and physical constraints of the DC MG are also satisfied, which improves the effectiveness and robustness of the proposed controller. To show the merits of the proposed approach, it is tested on a DC MG that feeds one PPL. Real-time model-in-the-loop (MiL) results show the performance improvements in the transient and steady-state obtained by the proposed control method compared to the state-of-the-art methods.
AB - This paper proposes a novel model predictive controller to minimise the effect of unknown pulsed loads on the DC microgrid (MG) side of shipboards. It is assumed that the level of the pulsed power loads (PPLs) is not determined in prior for which the authors propose a novel non-linear power observer. By employing the so-called freezing technique, a novel model predictive scheme is utilised to optimally stabilise the overall DC shipboard MG. Furthermore, different constraints on the current of the DC source and the energy storage system (ESS) are considered in the predictive controller to make it more realistic and practical. Compared to the exiting results, the proposed approach can optimally design the injecting current of the ESS so that the practical and physical constraints of the DC MG are also satisfied, which improves the effectiveness and robustness of the proposed controller. To show the merits of the proposed approach, it is tested on a DC MG that feeds one PPL. Real-time model-in-the-loop (MiL) results show the performance improvements in the transient and steady-state obtained by the proposed control method compared to the state-of-the-art methods.
UR - http://www.scopus.com/inward/record.url?scp=85072045150&partnerID=8YFLogxK
U2 - 10.1049/iet-pel.2018.6159
DO - 10.1049/iet-pel.2018.6159
M3 - Journal article
SN - 1755-4535
VL - 12
SP - 2155
EP - 2160
JO - IET Power Electronics
JF - IET Power Electronics
IS - 9
ER -